- #Sinano ac servo driver install
- #Sinano ac servo driver drivers
- #Sinano ac servo driver driver
- #Sinano ac servo driver manual
- #Sinano ac servo driver software
(4) If there is a big magnet switch or welding equipment, which may generate electronic noise, near the Driver installation, then a line filter is required.įor single-phase power source: DELTA 06DPCW5įor three-phase power source: DELTA 08TDS4W4 Insulation from water, water mist, or cutting fluid is required. (3) The Driver shall not be installed in an environment where corrosive gases, excess dust, or metal power is present. (2) Use rubber pad or shock absorber to insulate vibration if there is vibrating equipment nearby. (1) If installed in a confined chassis, please provide necessary ventilation system to maintain the environmental temperature of the Driver below 55℃. The machine, which the Driver and motor are installed must be single-point grounded. To prevent electric leakage, connect the motor ground to the FG terminal of theĭriver and connect this FG to Class 3 grounding. Disconnect the power if the Driver/Motor unit is not used for a prolonged period.Ĥ. While power on the Driver and/or motor, stand clear from the unit to prevent personal injury caused from erroneous operation.ģ. If it is necessary to touch the terminal or open the driver chassis, please wait at least 10 minutes before continuing.Ģ. Many high volume capacitors are used in the Driver circuit these capacitors remain charged even if the unit power is been shut off. Please use the original packaging for driver relocation and handle with care.ġ. No damage to the packaging material occurred during transportation. (Please see the Driver Specification for correct driver.)ģ. The capacity of the driver matches with the motor to be driven. The motor (s) and driver(s) are the same as ordered.Ģ.
Procedures for Panel Operation are described in Chapter 3.įinally, the Alarm Codes are given in Chapter 4.Īfter receiving the shipment from your supplier, please verify the following:ġ. Wiring information is shown in Chapter 2. In this manual, the installation related information such as Dimensions and Specifications are described in Chapter 1.
#Sinano ac servo driver manual
This manual is intended for use by vendors who are responsible for installing and setting up TSDA series Driver consequently, it assumes a basic working knowledge of
#Sinano ac servo driver install
This manual provides the information you need to install and configure TSDA seriesĭriver. It is highly recommended that the user is familiar with this manual and performs all setup and operations with caution.
However, erroneous operation may result in unpredictable accident and cause damage to the Driver or severe personal injury. Many safety related features have been built in theĭriver design.
#Sinano ac servo driver drivers
TSDA series Drivers use the latest servo technology to provide high-precision and versatile functions for driving TEDĬB,MB and CC series servo motors. Thank you for choosing TSDA series AC servo Drivers. Historical alarm code.24Ĭlear the historical alarm codes. The D1-N drive also supports EtherCAT field bus for high speed industrial motion control.
#Sinano ac servo driver software
Downloadable and free user interface software is easy to use but offers advanced functions for high performance. The D1-N drive achieves excellent following characteristics and effectively shortens cycle times. D1-N Series- AC Servo Drive D1-N series high performance servo drives are used for driving linear, direct drive, and AC servo motors. The D1 drive supports EtherCAT field bus for high speed industrial motion control. The D1 drive achieves excellent following characteristics and effectively shortens cycle times. D1 Series- AC Servo Drive D1 series high performance servo drives are used for driving linear, direct drive, and AC servo motors.
0 kommentar(er)
